一、 店面装饰砖工抹灰步骤
First, shop decoration masonry plastering steps
1、抹灰表面应光滑，洁净、接槎平顺，线角顺直，粘接牢固，无爆灰、脱层、裂纹、空鼓、掉粉等缺陷。
1. The plastering surface should be smooth, clean, smooth joint, straight line angle, firm bonding, without defects such as explosion ash, delamination, cracks, empty drum and powder dropping.
2、质量要求，试验方法及判定，装饰施工尺度要求准确到mm。
2. Quality requirements, test methods and judgments, decoration construction scale requirements to be accurate to mm.
（1）表面应洁净、接槎平顺，线角顺直，粘接牢固、无脱层、裂纹、空鼓，掉粉等缺陷。（目测，用小锤轻敲击）
(1) Surface should be clean, smooth joint, straight line angle, firm bonding, no delamination, cracks, empty drum, powder drop and other defects. (Visual, tapping with a hammer)
（2）表面平坦度≤4 mm（2 m靠尺，楔形塞尺）
(2) Surface flatness less than 4 m m (2 m gauge, wedge gauge)
（3）立面笔直度≤5mm（2m托线板，线锤）
(3) Vertical straightness less than 5 mm (2 m supporting plate, wire hammer)
（4）阴阳角笔直度≤4mm（2m托线板）
(4) The verticality of Yin-Yang angle is less than 4mm (2m tray)
（5）阴阳角方正度≤4mm（200mm阴阳角尺）
(5) The square degree of Yin-Yang angle is less than 4 mm (200 mm Yin-Yang angle ruler)
（6）分格条（缝）平直≤3mm（5m拉线，直尺）
(6) Lattice strip (seam) straight less than 3mm (5m drawing line, ruler)
每个相对独立空间，每项抽查4处，各项中若有2处以上（含2处）不符合要求，或有1处大于等于质量要求的150%即为不合格。空鼓而不裂的面积大于200c㎡即为不合格。
For each relatively independent space, there are four spot checks for each item. If more than two of the items (including two) do not meet the requirements, or one is greater than 150% of the quality requirements, it will be unqualified. The area of empty drum without cracking is larger than 200c_which is unqualified.
二、店面装饰砖工镶贴
2. Insertion of shop decorative bricklayers
1、基本要求。
1. Basic requirements.
（1）卫生间，厨房与其它区域的交接处应有防水措施。
(1) Waterproof measures should be taken at the junction of toilet, kitchen and other areas.
（2）面砖贴前应浸水2小时以上，待表面晾干后方可使用。
(2) Face tiles should be immersed in water for more than 2 hours before pasting, and can be used only after the surface is dried.
（3）每块砖应镶贴密实，缝隙均匀，周边顺直。
(3) Each brick should be compactly mounted, with even crevices and straight periphery.
2、墙面镶贴店面装饰施工要点，试验方法及叛定。
2. Main points, test methods and betrayal of wall-mounted shop decoration construction.
（1）无空鼓、掉落。（用小锤悄悄敲击，全数查验，空鼓面积大于总数的5%，或有掉落即为不合格。单块空鼓面积
(1) No empty drum or falling. (With a small hammer tapping quietly, full inspection, empty drum area greater than 5% of the total, or fall is not qualified. Single empty drum area
（2）镶贴应牢固，表面平坦洁净，无漏贴、错贴，缝隙均匀，周边顺直，砖面无裂纹，掉角，缺楞。（目测，分数查验，均应符合要求。）
(2) Insertion should be firm, flat and clean surface, no leakage or misplacement, uniform gap, straight surrounding, no cracks, corner drop and corrugation on the brick surface. (Visual and score checks should meet the requirements.)
If you have any questions, please remember us: Jinan store decoration http://www.saiyunzs.com, we will have more wonderful content for you one after another.
